Acrylic PVC Plastic Strip Heater Bender 24"/60CM Acrylic Plastic PVC Bending Machine Portable Hot Heating Bender for 1-6MM Thickness Plastic Sheet 110V 800W

SpecificationsInput Voltage: Ac 110VHeating Peak: Zw-300 420 ℃, the other 250 ℃Bending Material Thickness: 1mm-6mmHeating Width: 10-60 cm/3.9-23.6 inchPower: 800WProduct Size: 60*5*4cm(23.6*2*1.6inch)Net Weight: 3 kg/6.6 lbGross Weight: 3.05 kg/6.7 lbsPackage Dimensions (L x W x H): 87*20*12 cm/34.3*7.9*4.7 inchPackages1 X Acrylic Pvc Bending Machine Heater1 X Water Pump2 X Silicone Tubes1 X Temperature Controller1 X Water ThermometerInstructions1. Keep a cooling tank (barrel) of more than 30 liters. First, connect the heater body and the submersible pump with a silicone hose. Place the submersible pump in the cooling bucket, connect the power supply of the pump, and wait for the water to circulate out. (Note: the water temperature of the machine will keep rising for a long time. Please replace the cold water clearly. The temperature of the circulating water should not drop abruptly. When the water temperature exceeds 50 degrees, the power supply of the heater should be cut off in time, and the circulating water should be replaced later).2. Connect the thermostat with the hot bender and connect it to 220v power supply. Adjust the knob of the thermostat controller. The clockwise direction is to raise the temperature, and vice versa. When adjusting, it is not appropriate to rotate too fast in order to avoid damaging the thermostat. (Note: it is advisable to slowly adjust the thermostat to a reddish heat pipe. Excessive temperature will cause damage to the hot bending material and affect the service life of the hot bender).3. When the heating pipe reaches the required temperature, it can place the plastic sheet which needs to be hot-bended on the heating trough. When the sheet is soft enough to be folded manually, it can bend at various angles. According to the different materials, the setting time is different. Please determine the setting time according to the actual situation.

• 【Temperature Adjustable】PVC heating is uniform and the temperature can be adjusted. There are water circulation cooling devices on both sides of the heating tube to ensure that there will be no thermal deformation except where heating is needed. If bending thick plates, slotting bending, bending angle will be more beautiful, you can adapt to local conditions, flexible use.
• 【Safe tO Use】The acrylic bending machine is compact and easy to carry. The power supply and water pipe of the PVC bending machine are connected at both ends respectively, which is easy to assemble with the workbench. Separation of water and electricity makes your operation safer.
• 【Easy tO Use】The acrylic pvc plastic strip heater can not only be used alone, but also can be combined with multiple heaters. Thermoplastic materials with a thickness of more than 6 mm can be heated up and down by two heaters at the same time or combined with multiple heaters to heat multiple bending points at one time.
• 【Wide Application】The acrylic bending machine can process acrylic, organic board, pvc and various thermoplastic materials, widely used in decoration engineering, sign making, display cabinets, LED channel luminous character lighting, supermarket shelves, curtain walls, etc.